Portland CNC

Check out this video on how to get the best dust collection Use Optimal Dust Collection System Methods Size Matters - Our Dust Boot is design...

To use our Dust Boot, or install our ATC Pedestals, we advise disabling the Dust Dock movements. You also do need to remove the ShopSabre Dust Boot from the...

We made a change to the Dust Boots to make for a more solid connection between the bottom and top plates. That requires one quick upgrade to your Dust Boot ...

Dust Boot To use our Dust Boot with the standard ShopSabre CNC Router Blue ATC Rack, the Z-Tool probe must be located on the leftmost side of the rack. ...

We are intending to only sell our Dust Boot as a physical product.

Our Dust Boot is shipping now. Our current time to ship from order is one-week or less.

Here's a handful of ducting items we recommend for use with our Dust Boot: 5-inch x 10ft Flex Duct 5-inch Wire Clamps A Few Tips ...

To have your spindle raise higher during Tool Change, you can follow the guide below: Note: If you intend to use Dust Boot Spacers, you may want to decr...

Quick solution: E6000 adhesive. E6000 Glue on Amazon Easy to get at hardware stores too. Put a drop of glue in the hole where the alignment pin g...

If you've broken your Dust Boot, here's how to replace the red port. You'll need: Phillips #1 Screwdriver Hot Glue Gun for 1/2" g...